Toshiba LF600F - Manual (Page 76)

TOSHIBA ;6,F|8iA0,8|6,9|
Shown below is an example of changing the switch position setting from BOTTOM to TOP.
Key operation Display example Description
B:
MEAS MODE
MAIN DSP
SUB DSP
CUSTOM DATA
CUSTOM UNIT
LCD ADJUST
^SW POSITION
fSELl fENTl
Select "SW POSITION" in the configuration item
selection screen.
STEP1 B6:
SW POSITION
BOTTOM
The currently set switch position (BOTTOM in this
example) is displayed.
[ENT] Then press the [ENT] key.
[EXT] [ENT]
* If you press the [EXT] switch, you return to the
menu screen.
STEP2 B6:
SW POSITION
The switch name display at the bottom changes
(three keys [UP], [DWN] and [SET]).
BOTTOM At the same time, the cursor appears.
(The digit on which the cursor is positioned is
reverse-displayed.)
[ENT]
[U P] [DWN] [SET]
STEP3
[UP]/[DWN]
B6:
SW POSITION
HSH
Change the selection item using the [UP]/[DWN]
key.
When you have selected the desired item, press the
[SET] key.
[UP] [DWN] [SET]
STEP4
[SET]
B6:
SW POSITION
TOP
OK? ^
When you press the [SET] key. the selected item is
set temporarily and a message confirming you
whether the setting is OK is displayed.
If OK, press the [SET] key. If you want to redo the
setting, press the [NO] key.
[NO] [SET]
STEP5-1 B6:
SW POSITION
Pressing the [NO] key when you are asked "OK?"
causes the switch position setting to return to the
BOTTOM previous setting and enables you to redo the
setting. [NO]
fU P] [DWN] [SET]
I
STEP5-2(=END)
[SET]
B6:
SW POSITION
TOP
_ ixj]_ _ _
[ENT]
Pressing the [SET] key when you are asked "OK?"
causes the setting to be determined.
Then press the [EXT] key. You return to the menu
screen.
Pressing the [ENT] key enables you to restart
switch position setting from a state of TOP.
-
75
-