Toshiba LF600F - Manual (Page 66)

TOSHIBA 6 F 8 A 0 ; 8 6 9 .
8.2.7 Address Setting
Address setting described here is needed if optional PROFFBUS communication board is installed. For
details, refer to PROFFBUS communication instruction manual.
* Address setting is not necessary if PROFIBUS communication board is not installed.
8.2.8 Indicating Unit
You can select one of the engineering units listed below as an indicating unit.
• Flow velocity: m/s, ft/s
• Flow rate: mVs, mVmin, m^/h, mVd
1/s, 1/min, 1/h, 1/d
ml/s, ml/min, ml/h, ml/d
gal/s, gal/min, gal/h, gal/d
bbl/s, bbl/min, bbl/h, bbl/d
pt/s, pt/min, pt/h, pt/d
qt/s, qt/min, qt/h, qt/d
• Volumetric flow: m^, 1, ml, gal, bbl, pt, qt
• Other units: %, COUNT, RANGE, GRAPH, CUSTOM
• Code of volumetric flow direction:
Forward direction (when F or B is selected)
Reverse direction (when R or B is selected)
• Total difference flow:
Difference between total forward direction flow and reverse direction flow (when
total flow direction D is selected)
Note 1
Note 2
If COUNT, RANGE, GRAPH or CUSTOM is selected, the display is shown as
follows:
COUNT: displays totalized flow counts (8 digits) without a unit.
RANGE: displays the range number (1 to 4).
GPARH: The measured value (% value) is displayed as a bar graph.
In addition, the range No. of the range being measured.
CUSTOM: Displays the result obtained by multiplying mVmin by the custom
coefficient.
GRAPH display can be selected only in the sub screen.
-
65
-