6 f8 ao 8 6:9, Unit of span, Hysteresis – Toshiba LF600F User Manual
Page 78: Setting sequence of the span(range), Toshiba
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6 F8 AO 8 6:9
Unit of span
One of the following engineering units as a unit for the span can be selected. The unit is set for
the range 1 and the same unit applies automatically to other ranges - range 2, range 3 and
range 4.
• Flow velocity:
m/s, ft/s
• Flow rate:
mVs, mVmin, m^/h, mVd
U s , 1/min, 1/h, 1/d
ml/s, m 1/min, ml/h, ml/d
gal/s, gal/min, gal/h, gal/d
bbl/s, bbl/min, bbl/h, bbl/d
pt/s, pt/min, pt/h, pt/d
qt/s, qt/min, qt/h, qt/d
If you change the unit, the new span based on the newly set unit will be automatically
displayed.
Hysteresis
The hysteresis is the dead band used when multiple ranges are switched. The hysteresis can be
set from 0 to 25% in increments of 0.1%. The hysteresis setting is needed only when
automatic selection of multiple ranges is used.
Setting sequence of the span(range)
The following is the setting sequence of span (range).
* If multiple range is selected, compulsory range 1 to range 4 and hysteresis settings are
displayed.
-
11
-