Toshiba LF600F - Manual (Page 67)

TOSHIBA i6,F,8,A0,8,6,9,
In display setting, you can select either one of the two types, main (MAIN DSP) or/Sub (SUB DSP).
The main display setting and sub display setting are switched by the configuration item number.
B1: MAIN DSP Main display unit (display setting for the upper part of the screen)
B2: SUB DSP Sub display unit (display setting for the lower part of the screen)
The display setting can be checked/set by the following procedures.
Shown below is an example of changing the main display setting from % to ml/s.
Key operation Display example Description
B: Select "MAIN DSP" in the configuration item
MEAS MODE
^MAIN DSP
SUB DSP
CUSTOM DATA
CUSTOM UNIT
LCD ADJUST
SW POSITION
fSELl fENTl
selection screen.
STEP1
B1: The currently set display setting (% in this
MAIN DSP
%
example) is displayed.
[ENT]
Then press the [ENT] key.
[EXT] [ENT]
* Pressing the [EXT] key returns you to the
menu screen.
STEP2
B1: The switch name display at the bottom changes
MAIN DSP
Kfl •
(three keys [UP], [SEL] and [SET])
m At the same time, the cursor appears.
[ENT]
[U P] [SEL] [SET]
(The digit on which the cursor is positioned is
reverse-displayed.)
STEP3
B1: Use the [SEL] key to move the cursor to the
MAIN DSP
ml/|
second unit ^ the third unit and change the
display unit by pressing the [UP] key.
[SEL]0[UP]
[U P] [SEL] [SET]
Repeat this operation to change the display
unit to ml/s.
When the desired display unit is selected, press
the [SET] key to set the display unit
temporarily.
STEP4
B1; Pressing the [SET] key displays a message
MAIN DSP asking you to confirm whether the setting is
ml/s OK.
[SET] If OK, press the [SET] key. If you need to redo
OK?
[N01 fSETl
the setting, press the [NO] key.
-
66
-