Toshiba LF600F - Manual (Page 18)

TOSHIBA
,6,F,8,A0,8,6.9,
4. Installation
Safety Precautions for Installation
A
WARNING
Do not live circuits under environment of explosive atmospheres.
Live part of electric circuit or a high temperature department can cause explosion.
0
DON’T
Do not use parts of other products.
Protective performance degradation for hazardous location can cause explosion.
0
DON’T
■ Do not live circuits While assembly of all components is not over.
0
Protective performance degradation for hazardous location can cause explosion.
DON’T
Install per the National Electrical Code for the US (NEC, ANSI/NFPA 70) and the
Canadian Electrical code for Canada (CEC, CAN/CSA-C22.1) and the drawing
3S8A2532,3S8A2533 (Refer to Appendix 2.).
O
DO
Unsuitable conduit connections for hazardous location can cause explosion.
A CAUTION
■ Ground the LF600F and LF602F
independently from power equipment.
(100 ohm or less ground resistance)
A A Operating this product without
grounding can cause electric
QQ shock or malfunction.
■ Use an appropriate device to carry and install
the LF600F and LF602F.
If his product falls to the ground,
injury, or malfunction of or damage to
the product, can be caused.
DO
■ Install a switch and fuse to isolate the
LF600FF and LF602FF from mains power.
Power supply from mains
power can cause electric
shock or circuit break-down.
DO
■ Do not modify or disassemble the LF600F and
LF602F unnecessarily.
Modifying or disassembling this product
yly can cause electric shock, malfunction
or damage to this product.
DON’T
■ Do not work on piping and wiring with
wet hands.
Wet hands may result in
V^y electric shock
DON’T
^ The label shown left is placed
near the terminal board for power
supply to the converter.
Be alert to electric shock
-
17
-