9 custom coefficient setting, Toshiba – Toshiba LF600F User Manual
Page 70
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6|F,8iA0i8,6|9|
8.2.9 Custom Coefficient Setting
Set a coefficient for the custom value displayed when you have selected CUSTOM at display setting.
Displayed value at CUSTOM setting = measured value in m^/min unit x custom coefficient
Shown below is an example of changing the custom coefficient value from 1.00 to 2.25.
Key operation
Display example
Description
B;
Select "CUSTOM DATA" in the configuration item
MEAS MODE
MAIN DSP
SUB DSP
^CUSTOM DATA
CUSTOM UNIT
LCD ADJUST
SW POSITION
iSELl fENTl
selection screen.
STEP1
B3:
The currently set custom coefficient (1.00000 in this
CUSTOM DATA
1.00000
example) is displayed.
[ENT]
Then press the [ENT] key.
[EXT] [ENT]
* Pressing the [EXT] key returns you to the menu
screen.
STEP2
B3:
The switch name display at the bottom changes
CUSTOM DATA
(three keys [UP], [SEL] and [SET])
H.00000
At the same time, the cursor appears.
[ENT]
[U P] [SEL] [SETl
(The digit on which the cursor is positioned is
reverse-displayed.)
STEPS
B3:
Use the [SEL] key to move the cursor to the desired
CUSTOM DATA
digit and press the [UP] key to change the numeric
2.2@000
value.
[SEL]<^[UP]
Repeat this operation to change the setting value to
2.25.
[U P] [SEL] [SET]
When the value changes to the desired value, press
the [SET] key to set the custom coefficient
temporarily.
STEP4
B3:
Pressing the [SET] key displays a message asking
CUSTOM DATA
you to confirm whether the setting is OK.
2.25000
If OK, press the [SET] key. If you need to redo the
[SET]
OK?
^
(N01 [SETl
setting, press the [NO] key.
STEP5-1
B3:
Pressing the [No] key when you are asked "OK?"
CUSTOM DATA
causes the custom coefficient to return to the
[NO]
D-00000
[U PI [SELl [SETl
previous value and enables you to redo the setting.
STEP5-2(=END)
B3:
Pressing the [SET] key when you are asked "OK?"
CUSTOM DATA
causes the setting value to be determined.
2.25000
Then if you press the [EXT] key, you return to the
[SET]
menu screen.
If you press the [ENT] key, you can restart custom
[EXTl [ENTl
coefficient change operation from a state of 2.25.
* The custom coefficient setting precision is 5 digits. Therefore, the input value changes as
follows depending on the setting value:
Example) Input value, ”85713038" —^ After the setting is confirmed, "85713040”
-
69
-