Product inspection and storage, 1 product inspection, 1 unit – Toshiba LF600F User Manual
Page 12: Electromagnetic flowmeter main unit, Lf602f, Electromagnetic flowmeter converter 1 unit, Electromagnetic flowmeter detector 1 unit, One unit, One for the converter, 2 storage
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
^6,F,8,A0i8i6,9,
1. Product Inspection and Storage
1.1 Product Inspection
LF60*F series electromagnetic flowmeter is shipped in a cardboard container filled with
shock-absorbing materials. Open the package carefully and check as follows:
■ Make sure the following items are included in the package.
For the integral type (when a converter and detector are united)
LF600F
■1 unit
Electromagnetic flowmeter main unit----------------------------------------
Instruction manual------------------------- One each for the converter and detector
For the separate type (when a converter and detector are separated)
LF602F
Electromagnetic flowmeter converter---------------------------------------------- 1 unit
Electromagnetic flowmeter detector------------------------------------------------1 unit
Instruction manual------------------------ Once each for the converter and detector
For a converter unit
only
LF602F
Electromagnetic flowmeter converter-
instruction manual -----------------------
----------------- One unit
One for the converter
Inspect the flowmeter for indications of damage that may have occurred during shipment.
Make sure the type and specifications of the flowmeter are in accordance with the ordered
specifications.
If you cannot find the items listed above or any problem exists, contact you're nearest Toshiba
representative.
1.2 Storage
To store the electromagnetic flowmeter after opening the package, select a storing place as
follows and keep it under the conditions described below:
Æ CAUTION
(1) Avoid places where there is direct sunlight, rain or wind.
(2) Store the product in a well-ventilated place. Avoid places of extremely high humidity or
extremely high or low temperature. The following environment is recommended:
• Humidity range: 10 to 90% RH (no condensation)
• Storage temperature: -25 to +65° C
(3) Avoid places where vibrations or mechanical shock occur.
(4) If it leaves the cover of converter open while being stored, gradual deterioration of circuit
isolation can be caused. And then don’t open the cover until it is connected with wires.
(5) To put the flowmeter temporarily on the floor, place it carefully with something, such as
stopper, to support it so that the flowmeter will not topple over.
-
11
-