Cub Cadet 6 x 4 Big Country User Manual

Page 94

Section 5: The Fuel System

5 - 11

9.14. Release the cable tie that holds the throttle cable

in a loop.

9.15. Working at the front of the Big Country, Remove

the torx head shoulder screw that connects the
eyelet on the end of the throttle cable to the
throttle pedal, using a T30 torx driver and a ½”
wrench. See Figure 9.15.

9.16. Slide the rubber boot up and loosen the jam nuts

that hold the throttle cable housing to the slotted
bracket under the throttle pedal using two ½”
wrenches.

9.17. Thread the top nut all the way off the end of the

cable housing, and slip the throttle cable housing
out of the keyhole slot in the bracket.
See Figure 9.17.

Figure 9.15

Throttle Cable

Throttle Pedal

Rubber Boot

Figure 9.17

Keyhole Slot
in Bracket

Jam Nuts

9.18. Secure the new throttle cable to the old throttle

cable in such a way that it will not snag as it is
drawn through the channel under the floor of the
Big country.

9.19. To install the new cable, pull the old throttle

cable out through the engine compartment,
drawing in the new one in the process.

9.20. Separate the two cables.

9.21. Fasten the new cable to the throttle pedal and

bracket using a T30 torx driver and two 1/2”
wrenches.

9.22. Loop the new cable, and hold the loop in place

with a cable tie.

9.23. Secure the choke and throttle cable to the belt

guard using a barbed cable tie.

9.24. Install the parcel bin and console cup holder

using a 1/2” wrench and a 3/8” wrench.

9.25. Fold the seats down.

9.26. Position the new cable under the clamp on the

throttle cable bracket, and push the throttle cable
core through the clamp on the throttle input arm.
See Figure 9.26.

9.27. Tighten the clamp on the bracket using an 8mm

wrench.

9.28. With the throttle input arm fully relaxed, pull on

the throttle cable core to take-up any slack, and
lock it in position by tightening the clamp. us an
8mm wrench and a 10 mm wrench.

9.29. Depress the throttle pedal completely and com-

pare the travel of the throttle input arm to the
travel of the throttle pedal.

Figure 9.26

Tighten Clamps

Bracket

Throttle Input Arm Stop Screw