Cub Cadet 6 x 4 Big Country - Manual (Page 92)

Section 5: The Fuel System
5 - 9
5
7.11. To install the choke cable, cut the fish tape off of
the old choke cable, and attach it to the new
choke cable in such a way that it will not snag as
it is pulled back through the frame.
7.12. Use the fish tape method to route the new cable
back through the path of the original cable, and
adjust the cable as it is installed
7.13. Perform the “Choke Cable Adjustment” proce-
dure.
NOTES
New Choke Cable
Dash Support
Dash Panel
Trimmer Line
“Fish Tape”
Figure 7.11
8. Choke Cable Adjustment
8.1. Loosen the hose clamps on the hose from the air
filter to the carburetor, and remove the hose.
8.2. Position the Z-fitting on the end of the cable in
the hole in the choke arm, and install the cable
housing under the clamp on the choke cable
bracket. Do not tighten the clamp at this time.
8.3. Push the choke knob all the way in.
8.4. Set the cable housing position so that the choke
plate is completely open and tighten the cable
clamp.
8.5. Double check the position of the choke knob.
Figure 8.3
Choke Knob
Figure 8.4
Choke Plate Open