Cub Cadet 6 x 4 Big Country - Manual (Page 41)

Section 2: Clutch, Transmission, Brakes, Linkages
2 - 32
18.51.Place a small amount of grease on the shift
block and place it in the shift collar.
See Figure 18.51.
18.52.Place a small bead of RTV silicone sealant on
the mating surface of either transmission hous-
ing.
18.53.Gently place the left transmission housing on to
the right transmission housing, making certain
the gearshift lever engages the shift block.
See Figure 18.53.
18.54.Completely seat the housings and install all the
bolts.
18.55.Tighten the bolts in two steps, to a torque of
203 - 260 in-lbs in a criss-cross sequence using
a 12mm. wrench.
18.56.Using an appropriate driver and seal protector,
install the seal on the differential lock shaft.
18.57.Install the shift arm plate on the shift arm, and
secure it with a bolt. Tighten the bolt to a torque
of 203 - 260 in-lbs.
18.58.Proceed to brake assembly.
18.59.Press a new output shaft seal into each brake
cover, and slide a new o-ring onto the brake cam
arm. See Figure 18.59.
NOTE: Lubricate the o-ring with assembly lube
or universal (hydraulic) tractor transmission fluid
prior to installation.
18.60.Beginning on the left side, install steel plate in to
brake housing and alternate with friction disc
until all five plate and disc are installed.
See Figure 18.60.
Figure 18.51
Spacer
Shift
Block
Shift
Collar
Shim
Washer
Bearing
Input Shaft
Figure 18.53
Shift Shaft
Shift Arm
Engaging
Shift Block
Figure 18.59
Shaft
Seal
Brake Cam O Ring
Figure 18.60
Friction
Disc
Steel
Plate