Cub Cadet 6 x 4 Big Country - Manual (Page 71)

Section 4: Engine and Transmission Support Asssembly
4 - 2
1.7. Cover the carburetor to prevent foreign objects
from entering the engine.
1.8. Unbolt the air filter bracket from the air intake
shoulder using a 13mm wrench, and remove the
filter. See Figure 1.8.
1.9. Remove the three bolts that hold the air intake
shoulder to the cylinder heads using a 12mm
wrench and a 13mm wrench.
NOTE: The two bolts that hold the air intake
shoulder to the front cylinder head also pass
through the upper transmission support.
1.10. Loosen the nut and bolt that hold the upper
transmission support bracket to the transmis-
sion using two 9/16” wrenches.
1.11. Remove the two screws that hold the air intake
shoulder to the fan cover using an 8mm driver or
a screwdriver.
1.12. Carefully slip the fuel line and the fuel shut-off
solenoid wire free of the air intake shoulder, and
remove it.
1.13. Match mark and disconnect the choke cable
from the choke cable bracket and choke linkage
using a 7mm driver.
1.14. Match mark and disconnect the throttle cable
from the throttle cable bracket and throttle link-
age using a 7mm driver.
1.15. Remove the two bolts, flat washers, and rubber
washers that hold the hood closed using a 9/16”
wrench.
1.16. Tilt the hood forward to open it.
1.17. Carefully disconnect the negative cable from the
battery using a 7/16” wrench. See Figure 1.17.
1.18. Tilt both seats forward.
NOTE: The fuel tank is located under the
driver’s seat.
1.19. Turn the fuel valve to “OFF”. See Figure 1.19.
1.20. Disconnect the bullet terminal on the end of the
brown 14 AWG harness wire from the black wire
with a yellow tracer that leads to the fuel shut-off
solenoid.
Figure 1.8
Air Intake
Shoulder
Air Filter
Mounting Bolts
Throttle
Cable
Choke
Cable
Upper Transmission
Support
Negative
Battery Cable
Figure 1.17
Figure 1.19
Fuel Tank
Fuel Gauge
Fuel Level Sender
Fuel Return Line
Fuel Valve