Cub Cadet 6 x 4 Big Country - Manual (Page 29)

Section 2: Clutch, Transmission, Brakes, Linkages
2 - 20
15. Driven Clutch Pulley Removal and Replace-
ment
15.1. Set the parking brake
15.2. Place the shift lever in forward gear.
15.3. Loosen the bolt that secures the driven clutch
pulley to the input shaft of the transmission using
a 17 mm wrench.
15.4. Remove the drive belt from the driven clutch pul-
ley as described in the “Drive Belt Removal and
Replacement” section of this manual.
See Figure 15.4.
15.5. Completely remove the bolt and flat washer that
secure the driven clutch pulley to the input shaft
of the transmission.
15.6. Slip the pulley off of the shaft.
15.7. To install the driven clutch pulley, reverse the
removal procedure.
NOTE: Apply a small amount of anti-seize com-
pound to the splines that drive of the driven
clutch pulley prior to installing it on the Big Coun-
try.
NOTE: Apply Loctite 242  or an equivalent
thread locking compound to the threads of the
bolt that holds the pulley to the input shaft.
NOTE: Torque the bolt to 35-40 ft-lb.
NOTES
16. Driving Clutch Pulley Removal and Replace-
ment
16.1. If equipped with fixed chain guides, remove the
upper chain guide using a 9/16” wrench as
described in the “Chain Tension Adjustment”
section of this manual.
16.2. If equipped with rotary chain tensioners,
retract the tensioner and lock it into position with
a pin, as described in the “Rotary Chain Ten-
sioner” section of this manual.
16.3. Remove the belt as described in the “Belt
Removal and Replacement” section of this man-
ual.
16.4. Lock the driven clutch into position using a pry
bar between the head of one of the bolts that
holds the cover on the clutch and the washer
under the head of the bolt that holds the clutch to
the crankshaft. See Figure 16.4.
16.5. Remove the bolt that holds the clutch to the
crankshaft using a 9/16” wrench.
Figure 15.4
Bolt (loosened)
Driven Clutch Pulley
(belt removed)
Pry Bar
9/16” wrench
Figure 16.4