Cub Cadet 6 x 4 Big Country - Manual (Page 21)

Section 2: Clutch, Transmission, Brakes, Linkages
2 - 12
9.15. Slide the switch forward until the plunger on the
switch makes an audible “click”, indicating the
closure of the contacts within the switch.
NOTE: The plunger need not be fully depressed.
9.16. Secure the switch in this position by tightening
the screws that hold it to the bracket.
9.17. Perform the “Clutch Pulley Brake and Shift Inter-
lock Adjustment” section of this manual.
10. Clutch Pulley Brake and Shift Interlock Cable
Removal and Replacement
10.1. Remove the belt guard. Refer to the “Belt
Removal and Replacement” section of this man-
ual. See Figure 10.1.
10.2. Remove the hairpin clip and flat washer that hold
the ferrule to the interlock arm. See Figure 10.2.
NOTE: The ferrule is threaded onto the end of
the cable housing.
10.3. Push the ferrule down to release it from the lock-
out arm.
10.4. Disconnect the spring at the end of the cable
from the clutch pulley brake arm.
See Figure 10.4.
10.5. Remove the two bolts that hold the hood closed
using a 1/2” wrench, and open the hood.
10.6. Remove the hairpin clip and clevis pin that hold
the brake cable yokes to the brake pedal.
See Figure 10.6. Figure 10.1
Clutch Pulley Brake Arm
Driven Clutch Pulley
Figure 10.2
Interlock Arm
Cable
(operates clutch
pulley brake and shift
interlock arm)
Ferrule
Figure 10.4
Spring
(end of Cable)
Figure 10.6
Clevis Pin
Brake Cables
Brake Pedal
Shift Interlock
and Clutch Pulley
Brake Cable
Hairpin
Clip