Cub Cadet 6 x 4 Big Country - Manual (Page 64)

Section 3: Drive Axle Service
3 - 21
3
12.26.Press a new cup partially into one bore of the
end yoke. See Figure 12.26.
12.27.Seat the accessible end of the cross in the oppo-
site cup.
12.28.Use the universal joint press to push the two
cups together, driving the second cup deep into
but not completely through its bore.
See Figure 12.28.
12.29.Install the snap ring behind the second cup.
12.30.Use the universal joint press to push the first cup
into its bore until the cross is fully seated against
the second cup.
Figure 12.26
Figure 12.28
12.31.Install the snap ring behind the first cup.
See Figure 12.31.
12.32.Align the yokes with a blow from a soft hammer
to insure smooth operation.
See Figure 12.32.
Figure 12.31
Figure 12.32
Stiff Universal joint