Cub Cadet 6 x 4 Big Country - Manual (Page 15)

Section 2: Clutch, Transmission, Brakes, Linkages
2 - 6
5.13. Withdraw the pivot pin far enough to clear the
differential lock lever, and remove the lever. See
Figure 5.13.
5.14. Reverse the removal procedure to install the
differential lock lever.
5.15. Use the following procedure to install the differ-
ential lock cable.
5.16. Thread the first jam nut on the front (spring) end
of the cable housing all the way to the shoulder
of the threaded end.
5.17. Hook the spring onto the differential lock lever.
5.18. Position the cable housing in the bracket
attached to the frame. See Figure 5.18.
5.19. Tighten the second jam nut against the bracket
to secure the cable.
5.20. Insert the barrel on the end of the cable through
the hole in the differential lock arm by aligning
the cable with the slot in the arm.
5.21. Thread the first jam nut on the back (barrel) end
of the cable housing all the way to the shoulder
of the threads.
5.22. Position the cable housing in the bracket
mounted to the transmission.
5.23. Thread the second jam nut up against the
bracket to secure the cable.
5.24. Check cable adjustment after replacement.
NOTES
6. Differential Lock Cable Adjustment
6.1. To reach the differential lock cable, Perform
steps 1 through 7 of the “Shift Linkage Removal”
section of this manual.
6.2. Operate the differential lock lever and observe
the motion of the cable and differential lock arm
on the transmission. See Figure 6.2.
NOTE: To achieve full engagement, it may be
necessary to rotate the transmission clutch pul-
ley until the differential lock pins align with their
holes within the differential. At this point, addi-
tional movement of the differential lock lever will
be noticeable.
Figure 5.13
Bolt Hole
Partially Removed
Pivot Pin
Figure 5.18
Differential Lock Lever
Engage
Figure 6.2