Cub Cadet 6 x 4 Big Country - Manual (Page 34)

Section 2: Clutch, Transmission, Brakes, Linkages
2- 25
2
17.42.Loosen the jam nuts that hold the left brake
cable to the bracket on the frame using two 7/8”
wrenches.
17.43.Remove the rear jam nut and pull the cable
housing forward so that the cable core will pass
through the slot in the bracket.
17.44.Move the brake cable out of the way.
17.45.Repeat the steps used to disconnect the left side
brake cable on the right side.
17.46.Remove the bolts that hold differential lock
bracket using a 12 mm wrench, and remove the
differential lock bracket and lever.
17.47.Loosen then remove the four transmission
mounting bolts using a 24 mm wrench.
See Figure 17.47.
NOTE: The transmission will rest securely on
the four mounting ears after the bolts are
removed.
17.48.Insure that all linkages and the wiring harness
are clear of the transmission.
Figure 17.47
Mounting Bolts
17.49.Lift the transmission out of the Big Country.
See Figure 17.49.
17.50.To install the transmission, reverse the
removal procedure.
17.51.Check the adjustment of all linkages as they are
reinstalled.
17.52.Fill the transmission with 189 fl. oz. of universal
(hydraulic) tractor transmission fluid if it has
been drained.
18. Internal Transmission Service
18.1. Remove the transmission dipstick.
18.2. Use a 19mm wrench to remove the transmission
safety switch .
18.3. Carefully pry vent valve out of the housing.
See Figure 18.3.
Figure 17.49
Mounting Ears
Figure 18.3
Safety
Switch
Dipstick
Vent Valve