Cub Cadet 6 x 4 Big Country - Manual (Page 40)

Section 2: Clutch, Transmission, Brakes, Linkages
2- 31
2
18.46.Install the differential lock fork and shaft, as an
assembly, back into the right transmission hous-
ing. See Figure 18.46.
NOTE: Make certain the washer is placed
between the transmission housing and the snap
ring on the differential shaft.
18.47.Install the differential assembly into the right
transmission housing. See Figure 18.47.
NOTE: Engage the differential lock fork into the
differential slider as the differential goes in.
18.48.Seat differential bearing completely into its bore
while pushing the differential shaft all the way
into its bore.
Figure 18.46
Washer
Differential
Lock Shaft
Snap Ring
Figure 18.47
Differential
Assembly
Differential
Bearing
Differential
Lock Fork
18.49.Install the chain on the input shaft sprocket and
reduction sprocket and install both shafts into
the right side case as a unit. See Figure 18.49.
NOTE: It may be necessary to rotate the reduc-
tion shaft in order to engage the final gear on the
differential. See Figure 18.49.
18.50.Before installing left housing onto the right hous-
ing, make certain the shim washer is on the input
shaft bearing.
Figure 18.49
Input Shaft Linked to Reduction Shaft
Figure 18.49
Final
Gear
Reduction
Gear
Input Shaft