Cub Cadet 6 x 4 Big Country - Manual (Page 32)

Section 2: Clutch, Transmission, Brakes, Linkages
2- 23
2
17.17.Lift the bracket out as an assembly.
17.18.Remove the nut, bolt, and flat washer that hold
the upper transmission support to the transmis-
sion using 9/16” wrenches. See Figure 17.18.
17.19.Use a 12 mm wrench to remove the bolts that
hold the upper transmission support to the
engine.
17.20.Slip the upper transmission support out from
under the air intake shoulder and remove it.
17.21.Loosen the jam nuts that hold the differential
lock cable to the differential lock bracket using a
pair of 7/16” wrenches. See Figure 17.21.
17.22.Slip the cable housing out of the bracket.
17.23.Slip the barrel on the end of the cable out of the
hole in the differential lock arm.
Figure 17.18
Bolts to
Cylinder Head
Bolt to Transmission
Upper Transmission Support
Figure 17.21
Differential Lock Cable
Differential Lock Bracket
Harness Clamp
Jam Nuts
17.24.Remove the bolt that holds cable clamp securing
the wiring harness to the transmission using a
12 mm wrench.
17.25.Disconnect the top of each spring and shock
assembly as described in the “Spring and Shock
Assembly Removal and Replacement” section of
this manual. See Figure 17.25.
17.26.Loosen the hose clamps on both hoses that lead
to the air filter using a 5/16” driver.
17.27.Remove both hoses. See Figure 17.27.
17.28.Cover the mouth of the carburetor to prevent
foreign objects from entering the engine.
17.29.Remove the two nuts, bolts and washers that
hold the air filter assembly to the air intake
shoulder using two ½” wrench.
Figure 17.25
Air Filter
Hose to Carburetor
Hose to Plenum
Figure 17.27