Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 64)

2.9.7 Pump Kits
The Workstation pumps are easily converted to either a F10 or F40 pumphead to expand functional pump
flow rates as indicated in the table below.
Table 2-14.
Workstation Pump Configuaration Flow Rates
Workstation Pump Flow Rate Flow Rate with Maximizer
F10 0.01-10 ml/min 0.5-20 ml/min
F40 0.5-40 ml/min 1.0-80 ml/min
There are two kits, the F10 Pump kit and the F40 Pump kit. Each kit contains fully assembled pumpheads
with seals and check valves installed.
The F10 Pump kit contains the following items:
• Two F10 pumpheads assembled with check valves, seals, and O-rings
• Four F10 piston assemblies
• Installation instructions
PEEK tubing, orange, 1/6” OD x 0.02 ID is supplied in the Fittings kit of the DuoFlow system
The F40 Pump kit contains the following items:
• Two F40 pumpheads assembled with check valves, seals, and O-rings
• Four F40 piston assemblies
• One 2 ml mixer barrel extender
• Two mixer O-rings
• One 2mm UV flow cell
• PEEK tubing, green, 1/16” OD x 0.03” ID (rated to 3000 psi)
• Installation instructions
For a complete discussion of the Pump kits, refer to the separate documentation supplied with the kits.
DESCRIPTION OF SYSTEM COMPONENTS SYSTEM OVERVIEW
2-51