0 introduction to the system software – Bio-Rad BioLogic Signal Import Module (SIM) User Manual
Page 101

5.0
INTRODUCTION TO THE SYSTEM SOFTWARE
The BioLogic DuoFlow system software is run on computers running the Microsoft Windows
®
2000 operating
system. This chapter discusses the DuoFlow system software version 5.0.
5.1
SYSTEM INTERFACE
The Manual screen (Figure 5-1) is the first screen displayed when the BioLogic software is started. This
screen, like all DuoFlow screens, is grouped into the system menus, the control window, and the status bar.
The use of the Control window functions is discussed in Chapters 6 and 7 and in the separate
documentation for the Econo Gradient Pump (EGP) and the QuadTec UV/VIS detector. Note that many
menus and tool bar functions are grayed out and inacessible until you select, or enter a User name
in the Browser, see chapter 6.
•
Browser screen: Chapter 6
•
Manual screen: Chapter 7, section 7.1
•
Setup screen: Chapter 7, section 7.2
•
Protocol screen: Chapter 7, section 7.3
•
Run screen: Chapter 7, section 7.4
•
Post Run screen: Chapter 7, section 7.5
Figure 5-1. Layout of the Screen Display, showing the Manual Screen
DROP-DOWN
MENUS
CONTROL
WINDOW
MAIN
MENUS
STATUS
BAR
TOOLBAR
CONTROL
PANELS FOR
INSTRUMENTS
CONNECTED TO
INSTRUMENT
BUS
HINT
BOX
WORKSTATION
AND MAXIMIZER
VALVE CONTROL
BioLogic Duo-Flow -
Edit
Method
New
Method
New
Run Browser
Manual Setup
Setup
Protocol
wash
load
1
2
Run
Notes
Report
PostRun Log
Setup
Bio-Rad
Web
WINDOWS CONTROLS
WINDOW TITLE BAR
STATUS BOX
START
Maximizer+Gradient Pump: F-10
pH
Tris (20 mM)
1.00
7.05
0.25
Inlet B
Flowrate
ml/min
%
High limit:
0
1000
Low limit:
psi.
AVR7-3 at port 4
Workstation Valves
SVT3-2 at port 1
SV5-4 at port 2
P
L
2
1
2
1
3
4
STOP
START
STOP
Set
Set
psi.
Econo Gradient Pump 1
EGP %B
1.00
0
0.00
% Split
Flow
Direction
Flowrate
ml/min
%
%
Set
Mode:
System
Local
Mode:
System
Local
Mode:
System
Local
Lamp Type
Range
Deuterium
190 - 370 nm
nm
280
I
AVR9-8 at port 5
3
7
8
2
6
5
4
I
QuadTec Detector
ON
OFF
Zero Baseline
Wavelength Selection
UV
Conductivity
Clear
Traces
Resize
WL1 - 280nm
0.40
WL2 - 260nm
0.15
WL3 - 214nm
2.00
WL4 - 405nm
0.00
Flow Rate
EGP %B
0 %B
0.00 ml/min
0%
% Split
1.00ml/min
0 %B2
Maximizer + Gradient Pump: F10
UV
Conductivity
438 psi
1.003 AU
1.23 mS/cm
QuadTec
Econo Gradient
Pump
SIM1/pH
SIM1/SIG
0.548 Volt
7.00 pH
CHROMATOGRAM
DISPLAY
CONTROL
Settings
nm
260
nm
214
nm
405
File
View
Utilities
Options
Window
Help
Edit
Advance
Fraction Collector: BioFrac
START
STOP
Tube #:
Rack Pos:
Tube #:
A
Tube #: Grid #:
ml
Vol. left:
Mode:
System
Local
Start:
Rack:
End:
Fraction size:
1
1F
1A
1
90
1.00
A
B
2.00
100% Buffer B
0
2
4
6
8
10
Min. Tenth
AU
mS/cm
1.50
1.00
0.50
50
0.00
500.0
0.0
400.0
300.0
200.0
100.0
Fractions
Rack: F1 (12-13 mm tubes)
B
INTRODUCTION TO THE SYSTEM SOFTWARE
SYSTEM OPERATION
5-1
- BioLogic DuoFlow Pathfinder 80 System DuoFlow™ Chromatography System BioLogic DuoFlow Pathfinder 20 System DuoFlow™ Chromatography System BioLogic DuoFlow Maximizer 80 System DuoFlow™ Chromatography System BioLogic DuoFlow Maximizer 20 System DuoFlow™ Chromatography System BioLogic DuoFlow QuadTec 40 System DuoFlow™ Chromatography System BioLogic DuoFlow QuadTec 10 System DuoFlow™ Chromatography System BioLogic DuoFlow 40 System Chromatography System BioLogic DuoFlow 10 System Chromatography System