Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 104)

Table 5-2. Toolbar Buttons (continued)
Button Description
Opens the Protocol screen for creating and editing a method.
Opens the Run screen, from which you can start a run of the currently open
method. You will be prompted for a new run name prior to launching the run.
Opens the Notes screen that allows you to enter additional information about your
method and/or run. Notes are always editable, even after a run is executed.
Opens the PostRun screen that allows you to view and customize your
chromatogram prior to printing.
Opens the run log (Read Only) for the current run and displays the events that
occurred for the run. The button for the EZLogic integration program replaces this
button when it is installed.
EZLogic Integration button appears when the EZLogic integration software is
installed; this button replaces the Log button.
Enables the selection of up to 8 instrument traces to display on the screen and on
the printed report. The trace options are: UV detector, Conductivity monitor, pH,
system backpressure, theoretical %B concentration, four QuadTec wavelengths,
and detector traces acquired via the System Interface Module (SIM).
Available only in the Manual screen. Displays a screen that enables the following
inputs:
• Econo Gradient Pump (EGP) split time period when the EGP is used.
• QuadTec UV/VIS detector time constant when the QuadTec detector is used.
• Pump purge rate.
• Signal Import Module (SIM) signal parameters.
Available only when the Maximizer is used with the system. This allows you to
switch between buffer blending and non-buffer blending modes. In buffer blending
mode, a window listing buffer systems available for use is displayed.
If your controller has internet access, selecting this button takes you to the Bio-Rad
web page.
INTRODUCTION TO THE SYSTEM SOFTWARE SYSTEM OPERATION
5-4
Protocol
wash
load
1
2
Run
PostRun
Notes
Log
Integ.
Setup
Settings
Bio-Rad
Web
Setup