Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 156)

Scouting Wizard Step 3
This dialog is used to set the number of runs to be performed, name each run and set the parameters for
the scouted steps.
• Number of runs: Sets the number of runs to be performed as part of the scout experiment.
• Auto-name: When selected, this feature automatically generates run names based on the current
Run 1 run name. Refresh updates the run names.
• Auto-increment: Automatically generates scout run parameters by incrementing the Run 1 scout
parameter by the Increment Value. The scout Increment Value can be positive or negative. Note, you
should create your protocol with the appropriate starting value before defining the scout.
• Finish: Saves the scout setup. Note, the protocol cannot be edited once a scout has been defined
unless the scout step is deleted.
Scouting Wizard - Step 3
Next > > Finish < < Back Cancel
Refresh
Auto-naming
5 Number of Runs:
Gradient initia
Run 1 Scout %B (Gradient, Intial %B) 0.00
Run Name %
0.00
5 Increment Value:
Auto-increment
Run 2 Scout %B (Gradient, Intial %B) 5.00 5.00
Run 3 Scout %B (Gradient, Intial %B) 10.00 10.00
Run 4 Scout %B (Gradient, Intial %B) 15.00 15.00
Run 5 Scout %B (Gradient, Intial %B) 20.00 20.00
MODES OF OPERATION SYSTEM OPERATION
7-27