Lenze PC-based Automation Industrial PC - Manual (Page 57)

2.5 EN - 01/2012
L
57
Industrial PC | Parameter setting & configuration
Web-based parameterisation with »WebConfig«
User interface
7.4.7.1 CAN communication card (MC-CAN2)
7.4.7.2 EtherCAT communication card (MC-ETC)
This user interface displays the parameters of the MC-ETC communication card. An
Industrial PC can maximally have one MC-ETC card!

Note!
The parameters can only be viewed if the corresponding MC-CAN2
communication card is inserted. Two communication cards per IPC can be
plugged in maximally!
Button Function
The MC-CAN2 button displays the parameter list of the MC-CAN2
communication card.
MC-CAN2 interface x Parameters of the x interface of the
MC-CAN2 communication card
• The MC-CAN2 Interface x button displays the parameters of the
respective interface (1 or 2) of a MC-CAN2 communication card.
• In addition, the button displays which card the respective interface
belongs to.
• The parameters of the communication card are listed in the following
section in numerically ascending order:
CAN communication card (MC-CAN2) ( 162)

Note!
The parameters can only be viewed if the corresponding MC-ETC
communication card has been installed!
Button Function
Display parameters of the MC-ETC EtherCAT communication card
• The parameters of the communication card are listed in the following
section in numerically ascending order:
EtherCAT communication card (MC-ETC) ( 172)
Display interface parameters of the MC-ETC EtherCAT communication card
• This user interface displays the interface parameters of the EtherCAT
communication card.
Display master settings of the MC-ETC EtherCAT communication card
• On this user interface the parameters of the EtherCAT master are set or
displayed.
Parameters of the EtherCAT master
• This user interface sets and displays the statistics of the EtherCAT master.
Parameters of the EtherCAT slaves
• This user interface sets and displays the parameters of the EtherCAT
slaves.
• After pressing the button, the information of the first slave can be
viewed. In order to display the information of another slave the desired
node address must be entered in 1095.2.