Lenze PC-based Automation Industrial PC - Manual (Page 36)

Industrial PC | Parameter setting & configuration
System structure
Engineering PC
36
L
2.5 EN - 01/2012
5 System structure
This chapter gives you an overview of the general system structure in control technology.
5.1 Engineering PC
 The Engineering PC serves to:
– parameterise, configure and maintain the IPC: »WebConfig«, »Engineer«),
– parameterise, configure, and maintain the field devices connected
(»Engineer«, »Global Drive Control«),
– program the IPC (»PLC Designer«),
– creating a visualisation project (»VisiWinNET®«)
– the backup/restore preparation with »IPC Backup & Restore«.
5.2 Industrial PC
 The following programs run on the Industrial PC:
– the control software (L-force Logic, L-force Motion),
– the fieldbus drivers,
– the optional visualisation software, and
– additional services (data manager, web server, logbook).

Further information can be found in the respective documentation of the
corresponding Engineering software.