Lenze PC-based Automation Industrial PC - Manual (Page 50)

Industrial PC | Parameter setting & configuration
Web-based parameterisation with »WebConfig«
User interface
50
L
2.5 EN - 01/2012
According to the equipment of the Industrial PC, deviating components are shown by use
of the menu control fields.
Detailed information on the parameters can be found in the section entitled
Parameter
reference
( 125)
Area Information
Menu buttons  Parameters of the standard device of the Industrial PC ( 51)
• Parameter list 1: All parameters of the standard device
• Parameter list 2: All parameters of the installed extension cards
• PLC parameters
• Ethernet (on board) parameters
• Panel parameters
 Diagnostics/Command execution ( 52)
• Logbook parameters
• Logbook of the Industrial PC
• Device commands
• Remote control
 User management ( 55)
• Setting users 1-10
 General parameters ( 56)
• Time
• UPS settings
• Monitoring functions
• Memory
• Identification
 Extension card parameters ( 56)
Note:
• The represented parameters of slots 1 and 2 depend on the corresponding extension
modules that are installed!
• The additional buttons for the actually installed extension cards are automatically
added to the menu buttons.
• The top-down order of the buttons corresponds to the order in which the extension
cards have been installed (slot 1, slot 2).
• In the following section, the parameters of the communication cards are listed in
numerically ascending order: Industrial PC extension modules ( 161)
 Polling ( 58)
 Language selection ( 58)
Buttons  Parameter list buttons ( 58)
Display area  Parameter display
Depending on the selected menu button, the parameters can be viewed in this area.
• Code numbers
• Name of the code
• Representation of the display, entry, selection, control and list fields.