Lenze PC-based Automation Industrial PC - Manual (Page 10)

Industrial PC | Parameter setting & configuration
About this documentation
10
L
2.5 EN - 01/2012
Further technical documentation for Lenze components
Further information on Lenze components which can be used in connection with "PC based
Automation" can be found in the following documentation:
Mounting & wiring Legend:
 MA 8400 StateLine/HighLine  Printed documentation
 MA 9400 StateLine/HighLine Online help/PDF
 MA EPM-Txxx (I/O system IP20) Abbreviations used:
 MA EPM-Sxxx (I/O system 1000) SHB System Manual
 MA 8200 vector BA Operating Instructions
 EMC-compliant wiring 8200 vector MA Mounting Instructions
 MA ECSxS/P/M/A axis modules SW Software manual
 MA ECSxE power supply modules KHB Communication manual
Accordingly for built-in variants:
• Built-in unit
• Push-through technique
• Cold plate technology
 MA MC-CAN2 communication card
 MA MC-ETC communication card
 MA MC-ETH communication card
 MA MC-PBM communication card
 MA MC-PBS communication card
 MA MC-MPI communication card
 MAs for the communication modules
Parameterisation, configuration, commissioning
SW 8400 StateLine/HighLine frequency inverters
SW 9400 StateLine/HighLine/PLC controller
 9400 HighLine commissioning guideline
SHB I/O system IP20 (EPM-Txxx)
SHB I/O system 1000 (EPM-Sxxx)
SHB 8200 vector
BA ECSxS "Speed and Torque" axis module
BA ECSxP "Posi & Shaft" axis module
BA ECSxM "Motion" axis module
BA ECSxA "Application" axis module
BA ECSxE power supply module
KHBs for the communication modules
Programming
SW 9400 function library
Establishing a network
KHBs for the communication modules