Lenze PC-based Automation Industrial PC - Manual (Page 31)

2.5 EN - 01/2012
L
31
Industrial PC | Parameter setting & configuration
Commissioning
Configuring the Industrial PC
4.5.1 Touch display calibration

Tip!
Use a ballpoint pen with retracted cartridge for the touch calibration or a special
PDA/touch pen. In this way the calibration can be carried out more precisely.
Touch calibration is required if...
 ...you replace the CF card,
 ...you have updated the IPC software,
 ...a USB data carrier with backup / restore configuration has been connected,
 ...the Industrial PC remains in the service mode due to start-up problems,
 ...the Industrial PC detects a change in the hardware configuration when the system is
started.

How to calibrate the touch display:
1. If the touch calibration cannot be viewed, press function key <F3>.
• The icon appears on the screen surface.
2. Press the red-white icon displayed on the screen with your finger, PDA/touchpen,
or similar.
• The icon skips from its initial position to the upper left-hand corner.

Note!
• The touch calibration can be viewed for 15 seconds. Then the touch display
remains in an uncalibrated state so that the touch function does not properly
work. When the system is started again, the Industrial PC carries out another
touch calibration.
• The touch calibration can be started manually:
– Via one of the function keys, standard setting ,
– In the Windows® CE control panel on the IPC
Control panel
( 25)