Lenze PC-based Automation Industrial PC - Manual (Page 44)

Industrial PC | Parameter setting & configuration
Web-based parameterisation with »WebConfig«
Parameterisation via codes
44
L
2.5 EN - 01/2012
7 Web-based parameterisation with »WebConfig«
This chapter provides information on the parameterisation of the Industrial PC using web-
based parameterisation.
7.1 Parameterisation via codes
All settings by means of which you parameterise the Industrial PC are summarised in a
parameter list that is numbered serially. The individual entries of this list are called "codes".
Each code can be addressed via a number.
Codes can also contain subparameters. They are also numbered and can be addressed via
a subindex. With the code number and the subindex you can address each parameter
unambiguously.
The web-based parameterisation can be carried out LOCALLY on the Industrial PC or
REMOTELY via http by each Engineering PC transmitted which can be reached via the
network. The Engineering PC is a workplace PC including the Windows® XP operating
system.

Tip!
The web server and the »WebConfig« for the web-based parameterisation are
preinstalled on the Industrial PC.
 Parameterisation with the »Engineer« can be found in the chapter
Parameterisation using the L-force »Engineer«
( 38)