INFICON MDC-360 Thin Film Deposition Controller - Manual (Page 59)

MDC-360 DEPOSITION CONTROLLER
4-27
Two screens are required to program the Discrete outputs. The first screen
provides for selecting the output to be programmed, while the second screen
provides for the actual programming, including the output name.
Selecting Program Outputs from the System Setup menu will present the Select
Output screen.
PROGRAMMING AND CONTROLLER SETUP
Figure 4-9 Select Output screen
electing an output with the Right-arrow or Enter key will present the screen
hich permits definition of the output, as shown below.
ft-arrow, Right-arrow, Up-arrow and Down-arrow keys provide access to
tput Nam d#, pin# and Condition string edit fie me
a ed to the logical input. Any entry other than 1 or 2 will be ignored
card#, as will a pin# less than 2 or greater than 9.
S
w
The Le
the Ou
e, car lds. A 16-digit na
can be ssign
for the
Figure 4-10 Program Output Screen
dition string is a logical statement that determines the state of the
e condition string is evaluated as true.
the relay is open. Each output condition string is evaluated ten times
ery 100 milliseconds).
Select Output: 01 >End of Process <
02 Wire feed Al
03 Layer Complete
04 Procs Complete
05
Card# Pin#-Rt
tions :> Al & FeedHold
<
rators: 1=!, 2=(, 3=), 4=&, 5=|
or conditio s, to validate.
06
07
to select 08
↓
Output Name: Wire Feed Al 1 2 21
Condi
Valid ope
Press 0 f
n
The output con
output. The output relay is closed when th
Otherwise,
per second (ev