INFICON MDC-360 Thin Film Deposition Controller - Manual (Page 35)

MDC-360 DEPOSITION CONTROLLER
4-3 PROGRAMMING AND CONTROLLER SETUP
record passwords, because if you forget a password it will not be possible to
gain access to the protected item!
4.1.5.1 VIEW/RUN PROCESS PASSWORD
to view or run a process. To set this
m
ancel
a password other than 0000 has been installed, it
will not be displayed unless re-entered.
,
e Select
d
the
ot
yed unless re-entered.
ion to change the
password. Press 1 to confirm and 0 to cancel the change. Each time you want to
to enter the correct password. Once a
re-
METER/STATUS DISPLAY CONTRAST
am key
decrease the contrast. It may take
The View/Run password is required
password, select View/Edit Process from the Main Menu, select the process fro
the Select Process screen. Move the cursor onto the View/Run password, type in
your password (4 digit string), then press the Enter key. A message will pop up
asking for verification to change the password. Press 1 to confirm and 0 to c
the change. Each time you want to view or run this process, you will now be
asked to enter the correct password. Note that the Edit Process password takes
precedence over the View/Run password. If you know the Edit password, you
can also view the process. Once
4.1.5.2 EDIT PROCESS PASSWORD
The Edit process password is required to edit a process. To set this password
select View/Edit Process from the Main Menu, select the process from th
Process screen. Move the cursor onto the Edit password, type in your passwor
(4 digit string), then press the Enter key. A message will pop up asking for
verification to change the password. Press 1 to confirm and 0 to cancel the
change. Each time you want to edit this process, you will be asked to enter
correct password. Once a password other than 0000 has been installed, it will n
be displa
4.1.5.3 EDIT MATERIAL PASSWORD
The Edit material password is required to edit a material. To set this password,
select View/Edit Material from the Main Menu, select the material from the
Select Material screen. Move the cursor down to the Material Password
parameter, the last item in the list, type in your password (4 digit string), then
press the Enter key. A message will pop up asking for verificat
edit this material, you will be asked
password other than 0000 has been installed, it will not be displayed unless
entered.
4.1.6 ADJUSTING PARA
The Parameter/Status display contrast can be adjusted by using the Progr
in conjunction with the Up-arrow and Down-arrow keys. Hold down the Program
key and press the Up-arrow key to increase the contrast. Likewise, hold down the
Program key and press the Down-arrow key to
several seconds for the change in contrast to become apparent.