INFICON MDC-360 Thin Film Deposition Controller - Manual (Page 16)

MDC-360 DEPOSITION CONTROLLER
Rotator Delay 0 to 99 sec
Source Voltage Range 2.5, 5, 10 volts
1.3.10 RECORDER PARAMETERS
Recorder #1/#2 Output Rate, rate dev., power or thickness
Recorder #1/#2 Scale Full scale %, 2/3 digit
1.3.11 UTILITY SETUP PARAMETER
Crystal Frequency 2.5, 3, 5, 6, 9, 10 MHz
Simulate Mode On/Off
Interface Address 1 to 32
Attention Volume 0 to 10
Alert Volume 0 to 10
Alarm Volume 0 to 10
Data Points/Minute 30,60,120,300,600 PPM
Time 0 to 23:59
Date MM/DD/YY
1.3.12 OTHER
Input Power Requirements 100, 120, 200, 240 VAC; 50/60 Hz;
25 watts
Operating Temperature Range 0 to 50
°C
Physical Weight 10 LB
Physical Size 19” rackmount case
3 1/2” high x 9 3/8” deep
1.4 ACCESSORIES
Part Number Description
179215 Dual Source/Sensor Board
179216 Passive I/O Board
179217 IEEE-488 Communication Board
179218 Internal Storage Data/Time Clock
179219 RS-232 to RS-485 conversion
179220 Remote Power Handset
179239 Active I/O Board
180200-4 DCM-200 software 3.5” diskette
123200-5 SH-102 Sensor Head , cables, and
carousel of 10 each 6MHz Gold SC-
101 sensor crystals
124201-4 SO-100 Oscillator with 6" and 10'
BNC Cables.
GENERAL DESCRIPTION 1-6