INFICON MDC-360 Thin Film Deposition Controller - Manual (Page 55)

MDC-360 DEPOSITION CONTROLLER
4-23
any of its six crystals while the dual sensor head uses two sensor inputs to
measure either crystal.
d (4 digit string) This parameter defines the edit password
ng other than 0000 it will not be
interface with the vacuum system and are described
48. Tooling #2 (10.0 to 499.9%)
This parameter defines the tooling factor for the backup sensor head
49. Backup Crystal (1 to 8)
This parameter defines the backup crystal number.
50. Material Passwor
for the material. If the password is set to anythi
displayed, and when you attempt to edit the material you will first be asked to
enter the correct password.
4.3.3 SYSTEM SETUP
Choosing the Edit System Setup option from the Main Menu screen will present
the System Setup Menu options as shown in Figure 4-7. These options allow for
setting up the controller to
below.
System Setup: >Edit Display Setup<
Program Inputs
Program Outputs
m Actions
Edit DAC Setup
Progra
Edit Sensor Setup
PROGRAMMING AND CONTROLLER SETUP
Figure 4-7 System Setup Menu screen
Edit Source Setup
Edit Utility Setup
4.3.3.1 EDIT DISPLAY SETUP
Selecting Edit Display Setup will present the Display Setup screen.
Display Setup
Pause On Layer Complete >Yes<
Thickness Graph Scale 3-digit
Time To go Display Estimated Layer
Thickness Vs. Time Graph Disabled
Rate Vs. Time Graph Enabled
Rate Dev. Vs. Time Graph Enabled
Figure 4-8 Display Setup Screen
Power Vs Time Graph Disabled
↓