Allied Telesis AT-S63 - Manual (Page 765)

AT-S63 Management Software Menus Interface User’s Guide
Section VII: Management Security 765
Enabling or Disabling TACACS+ or RADIUS
To enable or disable the server-based authentication feature on the switch
and to configure the RADIUS or TACACS+ settings, perform one of the
following procedures.
Enabling
TACACS+ or
RADIUS
To enable TACACS+ or RADIUS, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 269.
Figure 269. Authentication Configuration Menu
Note
Selection 5, Passwords Configuration, is described in “Working With
the Manager and Operator Passwords” on page 55.
3. To select the active authentication protocol, type 2 to select
Authentication Method.
The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active on the switch at a time.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Authentication Configuration
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?