Allied Telesis AT-S63 - Manual (Page 460)

Chapter 20: SNMPv3
460 Section III: SNMPv3
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
ˆ Community Name
ˆ Security Name
ˆ Transport Tag
ˆ Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in “Creating an SNMP Community
String” on page 81, you cannot modify these Community Table entries
with the SNMPv3 Tables.
See the following procedures:
ˆ “Modifying the Community Name” on page 460
ˆ “Modifying the Security Name” on page 462
ˆ “Modifying the Transport Tag” on page 462
ˆ “Modifying the Storage Type” on page 463
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is displayed Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 9 to select Configure
SNMPv3 Community Table.
The SNMPv3 Community Table is shown in Figure 154 on page 457.
3. From the Configure SNMPv3 Community Table, type 3 to select Modify
SNMPv3 Table Entry.