Allied Telesis AT-S63 - Manual (Page 68)

Chapter 3: Basic Switch Parameters
68 Section I: Basic Operations
D o you want to reset static IP, Subnet and Gateway? [Yes/No] ->
5. If you type Y for yes, all switch parameters including the IP address,
subnet mask, and gateway address are changed to the default values.
If you type N for no, all switch parameters excluding the IP address,
subnet mask, and gateway address are changed to the default values.
The following prompt is displayed:
The Factory Defaults take effect only after the Switch
reboots.
Do you want to reboot the Switch now? [Yes/No] ->
6. Type Y to reset the switch.
Caution
The switch does not forward traffic while it reloads its operating
software, a process that takes approximately 20 seconds to
complete. Some packet traffic may be lost. You must reestablish
your management session if you want to continue managing the
switch.
7. Reestablish your management session.
8. From the Main Menu, type S to select Save Configuration Changes.
This step returns the active boot configuration file back to the default
settings.