Allied Telesis AT-S63 - Manual (Page 117)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 117
Forcing Port Renegotiation
Port renegotiation prompts the port to autonegotiate with the end node.
This option is useful if you believe that a port and end node are not
operating at the same speed and duplex mode.
To force port renegotiation, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 102.
2. From the Port Configuration menu, type 1 to select Port Configuration.
The following prompt is displayed:
Enter port-list ->
3. Enter the number of the port you want to reset. To reset a range of
ports, enter the first and last ports of the range, separated by a dash
(for example, 4-8). You cannot specify nonconsecutive ports (for
example, 5,7,9)
The Port Configuration menu is shown in Figure 26 on page 103.
4. From the Port Configuration menu, type F to select Force
Renegotiation.