Allied Telesis AT-S63 - Manual (Page 429)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 429
Configuring the SNMPv3 Target Address Table
This section contains a description of the SNMPv3 Target Address Table
menu and how to create, delete, and modify table entries. You use the
SNMPv3 Target Address Table menu to assign the IP address of a host
that is used for generating notifications. The Configure SNMPv3 Target
Address Table menu is linked internally to the Configure SNMPv3 Notify
Table through the Tag List parameter. The Configure SNMPv3 Notify
Table menu receives the host IP address through the configuration of the
SNMPv3 Target Address Table menu.
For each Target Address Table entry, you can configure the following
parameters:
ˆ Target Address Name
ˆ Target IP Address
ˆ UDP Port
ˆ Timeout Value
ˆ Number of Retries
ˆ Tag List
ˆ Target Parameters
ˆ Storage Type
The values for the Tag List parameter are configured with the Notify Tag
parameter in the Configure SNMPv3 Notify Table. See “Creating an
SNMPv3 Notify Table Entry” on page 422.
There are three functions you can perform with the Configure SNMPv3
Target Address Table menu.
ˆ “Creating an SNMPv3 Target Address Table Entry,” next
ˆ “Deleting an SNMPv3 Target Address Table Entry” on page 432
ˆ “Modifying an SNMPv3 Target Address Table Entry” on page 433
Creating an
SNMPv3 Target
Address Table
Entry
To create an entry in the Configure SNMPv3 Target Address Table menu,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.