Allied Telesis AT-S63 - Manual (Page 406)

Chapter 20: SNMPv3
406 Section III: SNMPv3
3. From the Configure SNMPv3 Access Table, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Access Table is shown in Figure 145.
Figure 145. Modify SNMPv3 Access Table Menu
4. To modify the Read View Name parameter, type 1 to select Set Read
View Name.
The following prompt is displayed:
Enter Group Name:
5. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
6. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify SNMPv3 Access Table
Group Name .... sales Security Model . v3
Context Prefix. Security Level . AuthNoPriv
Read View...... systemmanagers Context Match .. Exact
Write View .... salespeople Storage Type ... Volatile
Notify View ... salespeople Row Status ..... Active
1 - Set Read View Name
2 - Set Write View Name
3 - Set Notify View Name
4 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?