Allied Telesis AT-S63 - Manual (Page 332)

Chapter 16: Quality of Service
332 Section II: Advanced Operations
traffic classes must already exist. Separate multiple IDs with commas
(e.g., 4,11,13).
6 - Redirect Port
Specifies the port to which the classified traffic from the ingress ports is
redirected.
7 - Ingress Port List
Specifies the ingress ports to which the policy is to be assigned. Ports
can be identified individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
A port can be an ingress port of only one policy at a time. If a port is
already an ingress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
8 - Egress Port
Specifies the egress port to which the policy is to be assigned. You can
enter only one egress port.
A port can be an egress port of only one policy at a time. If a port is
already an egress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
6. After configuring the parameters, type C to select Create Policy.
The new policy is immediately activated on the specified ports.
7. To create another policy, repeat this procedure starting with step 3.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a
Policy
To modify a policy, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 82 on page 259.
2. From the Security and Services menu, type 6 to select Quality of
Service.
The Quality of Service (QoS) menu is shown in Figure 108 on page
313.
3. From the Quality of Service (QoS) menu, type 3 to select Policy
Configuration.
The Policy Configuration menu is shown in Figure 121 on page 330.
4. From the Policy Configuration menu, type 2 to select Modify Policy.
The following prompt is displayed: