Allied Telesis AT-S63 - Manual (Page 381)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 381
The Configure SNMPv3 Table menu is shown in Figure 139.
Figure 139. Configure SNMPv3 Table Menu
Note
The SNMP Engine field is a read-only field. You cannot change the
setting. The field displays the SNMP engine identifier that is
assigned automatically to the switch.
4. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The Configure SNMPv3 User Table menu is shown in Figure 140.
Figure 140. Configure SNMPv3 User Table Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure SNMPv3 Table
1 - SNMP Engine...............80:00:00:CF:31:00:30:84:FD:57:DA
2 - Configure SNMPv3 User Table
3 - Configure SNMPv3 View Table
4 - Configure SNMPv3 Access Table
5 - Configure SNMPv3 SecurityToGroup Table
6 - Configure SNMPv3 Notify Table
7 - Configure SNMPv3 Target Address Table
8 - Configure SNMPv3 Target Parameters Table
9 - Configure SNMPv3 Community Table
R - Return to Previous Menu
Enter your selection?
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure SNMPv3 User Table
Engine ID ................. 80:00:00:CF:03:00:30:84:FD:57:DA
User Name ................. jenny
Authentication Protocol ... MD5
Privacy Protocol .......... DES
Storage Type .............. NonVolatile
Row Status ................ Active
1 - Create SNMPv3 Table Entry
2 - Delete SNMPv3 Table Entry
3 - Modify SNMPv3 Table Entry
U - Update Display
R - Return to Previous Menu
Enter your selection?