Allied Telesis AT-S63 - Manual (Page 385)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 385
ˆ “Modifying the Privacy Protocol and Password” on page 387
ˆ “Modifying the Storage Type” on page 388
Modifying the Authentication Protocol and Password
To modify the Authentication Protocol and Password in an SNMPv3 User
Table entry, perform the following procedure.
7. Follow steps 1 through 5 in the procedure described in “Configuring the
SNMPv3 User Table” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 User Table menu is shown in Figure 139 on
page 381.
8. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 140 on page 381.
9. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.
The Modify SNMPv3 User Table is shown in Figure 141.
Figure 141. Modify SNMPv3 User Table Menu
10. To change the authentication protocol and password, type 1 to select
Set Authentication Protocol & Password.
The following prompt is displayed:
Enter User Name:
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify SNMPv3 User Table
Engine ID ................. 80:00:00:CF:03:00:30:84:FD:57:DA
User Name ................. wilson
Authentication Protocol ... SHA
Privacy Protocol .......... DES
Storage Type .............. NonVolatile
Row Status ................ Active
1 - Set Authentication Protocol & Password
2 - Set Privacy Protocol & Password
3 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?