Allied Telesis AT-S63 - Manual (Page 529)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 529
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 189 on page
528.
5. From the VLAN-MSTI Association menu, type 1 to select Add VLANs
to MSTI.
The following prompt is displayed:
Enter the MSTI ID [0 to 15] ->
6. Enter the MSTI ID to which you want to associate a VLAN.
A prompt similar to the following is displayed:
Enter the list of VLANs:
7. Enter the VLAN ID of the virtual LAN you want to associate with the
MSTI ID. You can enter more than one VLAN at a time (for example,
2,4,7). To view VIDs, refer to “Displaying VLANs” on page 571.
The MSTI ID retains any VLANs already associated with it when new
VLANs are added.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Removing a
VLAN from an
MSTI ID
To remove a VLAN from an MSTP ID, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 186 on page 517.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 188 on page 522
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 189 on page
528.
5. From the VLAN-MSTI Association menu, type 2 to select Delete
VLANs from MSTI.
The following prompt is displayed: