Allied Telesis AT-S63 - Manual (Page 408)

Chapter 20: SNMPv3
408 Section III: SNMPv3
To modify the Write View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 144 on page
400.
3. From the Configure SNMPv3 Access Table, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table menu is shown in Figure 145 on page 406.
4. To modify the Write View Name parameter, type 2 to select Set Write
View Name.
The following prompt is displayed:
Enter Group Name:
5. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model[1-v1, 2-v2c, 3-v3]:
6. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
The following prompt is displayed: