Allied Telesis AT-S63 - Manual (Page 55)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 55
Working With the Manager and Operator Passwords
There are two levels of management access on an AT-94xx switch:
manager and operator. When you log in as manager, you can view and
configure all of a switch’s operating parameters. When you log in as an
operator, you can only view the operating parameters; you cannot change
any values.
You log in as a manager or an operator when you enter the appropriate
username and password when you start an AT-S63 management session.
The default password for manager access is “friend.” The default
password for operator access is “operator.” Passwords are case sensitive.
Changing the
Manager or
Operator
Password
To change the manager or operator password, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 8.
Figure 8. Authentication Configuration Menu
3. From the Authentication Configuration menu, type 5 to select
Passwords Configuration.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Authentication Configuration
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?