Allied Telesis AT-S63 - Manual (Page 535)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 535
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 186 on page 517.
3. From the MSTP menu, type P to select MSTP Port Parameters.
The MSTP Port Parameters menu is shown in Figure 190 on page
533.
4. Type 2 to select Configure Per Spanning Tree Port Settings.
The following prompt is displayed:
Enter Spanning Tree (CIST/MSTI) List :
5. Enter the ID number of the CIST or MSTI where the VLAN containing
the port whose settings you want to configure has been assigned. You
can specify more than one ID number.
The following prompt is displayed:
Start port to configure: [1 to 26] -> 1
6. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
End port to configure: [1 to 26] -> 1
7. Enter the last port of the range. To configure just one port, enter the
same port here as in Step 6.