Allied Telesis AT-S63 - Manual (Page 433)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 433
3. To delete an SNMPv3 Target Address Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
4. Enter a Target Address Name.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
the entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. See the following procedures:
ˆ “Modifying a Target IP Address” on page 433
ˆ “Modifying the Target Address UDP Port” on page 435
ˆ “Modifying the Target Address Timeout” on page 436
ˆ “Modifying the Target Address Retries” on page 437
ˆ “Modifying the Target Address Tag List” on page 438
ˆ “Modifying the Target Parameters Field” on page 439
ˆ “Modifying the Storage Type” on page 440
Note
You cannot modify the Target Address Name parameter.
Modifying a Target IP Address
To modify the target IP address in an SNMPv3 Target Address Table
entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.