Allied Telesis AT-S63 - Manual (Page 896)

Chapter 48: TACACS+ and RADIUS Commands
896 Section IX: Management Security
SHOW AUTHENTICATION
Syntax
show authentication[=tacacs|radius]
Parameters
None.
Description
This command displays the following information about the authenticated
protocols:
 Status - The status of your authenticated protocol: enabled or
disabled.
 Authentication Method - The active authentication protocol. Either
TACACS+ or RADIUS protocol may be active. The TACACS+ protocol
is the default.
 The IP addresses of the authentication servers.
 The server encryption keys, if defined.
 TAC global secret - The global encryption code that applies to all
authentication servers.
 Timeout - The length of the time, in seconds, before the switch
assumes the server will not respond.
Entering the command without specifying either TACACS or RADIUS
displays the current status of the authentication feature and the specifics
of the currently selected authentication protocol. Specifying TACACS or
RADIUS in the command displays the specifics for that authentication
protocol.
Example
The following command displays the authentication protocol information:
show authentication
This command displays the RADIUS client:
show authentication=radius
This command displays the TACACS+ client:
show authentication=tacacs
Command
Available
AlliedWare Plus