Allied Telesis AT-S63 - Manual (Page 47)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 47
END Command
After configuring a feature, you’ll probably want to use the SHOW
commands in the User Exec mode or the Privileged Exec mode to verify
your changes. While you could move back through the modes with the
EXIT command, you may find the END command more convenient
because it jumps you directly to the Privileged Exec mode from any of the
modes below the Configure Terminal mode.
Figure 25. Returning to the Privileged Exec Mode with the END Command
Manager and
Operator
Accounts
The AlliedWare Plus interface has a manager access level and an
operator access level. When you log on as a manager, you are given
access to all the modes in the AlliedWare Plus Interface and have full
control over the unit. When you log on as an operator, you are restricted to
the User Exec mode from where you can view parameter settings and ping
other devices.
Privileged
Executive
Mode
User
Executive
Mode
Configure
Terminal
Mode
Multiple
Tree Mode
Spanning
Class-Map
Mode
Port
Mode
Interface
Line
Mode
Console
Policy Map
Mode
Class
Mode
VLAN
Database
Mode
end
Other
Modes