Allied Telesis AT-S63 - Manual (Page 238)

Chapter 13: Port Mirroring Commands
238 Section I: Basic Operations
SET SWITCH MIRROR
Syntax
set switch mirror= port
Parameter
mirror Specifies the destination port for the port mirror. This is the port
where the traffic from the source ports is copied. You can
specify only one port as the destination port. Specifying “0”
(zero) stops port mirroring so that the destination port can
again be used as a normal networking port.
Description
This command enables mirroring and specifies the destination port, or
stops port mirroring. To select the source ports, refer to “SET SWITCH
PORT MIRROR” on page 239.
Examples
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command stops port mirroring:
set switch mirror=0
AlliedWare Plus
Command
The AlliedWare Plus command for designating the destination port of a
port mirror is also the command for specifying the source ports. For
information, refer to the AlliedWare Plus command in “SET SWITCH
PORT MIRROR” on page 239.
Command
Available
AlliedWare Plus