Allied Telesis AT-S63 - Manual (Page 43)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 43
INTERFACE PORT Command
You use this command to move from the Configure Terminal mode to the
Port Interface mode where you configure the parameter settings of the
ports and add ports to VLANs and Quality of Service policies. The format
of the command is:
interface port
This example enters the Interface mode for port 21.
Figure 15. Moving from the Configure Terminal Mode to the Port Interface
Mode with the INTERFACE PORT Command
You can specify more than one port in the command to configure more
than one port at a time. This example enters the Interface mode for ports
11 to 15 and 22.
Figure 16. Specifying More Than One Port in the NTERFACE PORT
Command
The INTERFACE PORT command is also located in the Port Interface
mode so you don’t have to return to the Configure Terminal mode to
configure a different port. This example moves from the current Port
Interface mode to the Port Interface mode for ports 7 and 10.
Figure 17. Moving within the Port Interface Mode with the INTERFACE
Command
VLAN DATABASE Command
You use this command to move from the Configure Terminal mode to the
VLAN Configuration mode which you use to create VLANs. The format of
the command is:
vlan database
awplus(config)# interface 21
awplus(config-if)#
awplus(config)# interface 11-15,22
awplus(config-if)#
awplus(config-if)# interface 7,10
awplus(config-if)#